Download SCADAPack E Target 5 Technical Reference

48
7.3
SCADAPack E Target 5 Technical Reference
Storing a Project on the RTU
SCADAPack Workbench provides the facility for storing the IEC61131-3 "source" on the target RTU
along with the executing TIC code.
This facility allows the original code that generated the Workbench application to be stored on the
SCADAPack E RTU, and later uploaded to the Workbench.
The application upload facility is supported through the following SCADAPack E IEC 61131-3 interfaces:
via an RTU serial port configured as ISaGRAF
via Ethernet when RTU has ISaGRAF/TCP service enabled (see SCADAPack E Configurator TCP/IP
page)
IEC 61131-3 project Upload facilities are not supported via DNP3 communications using SCADAPack E
Configurator.
Downloading a Workbench Project to the Target
The SCADAPack Workbench project "source" can be downloaded along with the RTU TIC code. The
project is compressed by the Workbench and forms part of the application resource downloaded to the
RTU.
This applies to applications downloaded via the Workbench Debugger or via file transfer in an ".I5P"
package file. (See Remote Target Access 80 ).
'To include Workbench Project "source" with the execution code to download to the target, set the
Resource property Embedded Zip Source settings as shown below.
Embedding application source code