Download SCADAPack E Target 5 Technical Reference

92
10.2
SCADAPack E Target 5 Technical Reference
Service Descriptions
Status codes reported by the IEC 61131-3 target in SCADAPack E RTU diagnostics are in Hexadecimal
(hex) format.
ISaGRAF 5>> Error Code: 0x1234:5678
Detailed IEC 61131-3 target status codes are also visible in the SCADAPack Workbench using the
System Event log. When the workbench is connected to the target in Debug mode, press the yellow
lightning-bolt icon on the debug tool bar to start the system event logger (as shown below).
Start System Events
button
The Workbench system event log output represents IEC 61131-3 status codes using 8 digit hexadecimal
numbers.
It is easier to use the LAST 4 HEX DIGITS from the status code value when referencing the status codes
in the table below. The RTU status code and the table below presents the 8 digit hex number in two
groups of 4 digits for easier recognition.
These abbreviations are used in the table below.
CGM = configuration manager task on the IEC 61131-3 target
DSA = data sequential access
ETCP = target TCP communication task for SCADAPack Workbench to RTU target
communications
Exchange dispatcher = resource to resource communication coordinator
HSD = host system driver for resource to resource data exchange on the same device
ISARSI = target serial communication task between the SCADAPack Workbench and RTU
target
IXL,IXS = exchange layers for resource to resource communication
Service codes presented by the IEC 61131-3 target
IEC 61131-3 Service
Status
Code
(hex)
Description
Suggested Action
0x1201: Consumer binding variables Contact Schneider Electric
000A
unsuccessful
technical support
System Layer
0x1202: System pool allocation
1000
unsuccessful
0x1202: Start-up unsuccessful. Too
1001
many initialisations
Contact Schneider Electric
technical support