Download MillenniumML Users Manual

Transcript
the next available dimmer in the patch as a default. This keeps fixture slot allocations simple. However, the
default DMX channel assigned may not control a physical dimmer for lamp intensity control. In this case you will
have to assign a dimmer to the fixture. The Modify Fixture dialog will display controls in the Remote Dimmer
group if the fixture requires one.
To select a dimmer choose either Port 1 or Port 2 by clicking on the appropriate radio button. Then, change the
DMX channel for the selected port using numeric entry or the up/down controls. The up/down can be controlled
using the mouse or the up/down arrow keys. If the dimmer you chose is currently assigned (patched) to another
channel, a message box is displayed asking if you are
sure you wish to complete the patch.
Upon completing all changes, click OK to assign the modifications or CANCEL to ignore the changes.
Replacing Fixtures
To open the "Replace With Fixture" dialog, select the fixture to replace using the mouse or up/down arrow keys.
Click on or press S3 (REPLACE WITH).
This dialog allows you to replace the selected fixture with one that has a number of attributes that are equal to or
less than the fixture being replaced. The example above shows a Technobeam, with 18 attributes being replaced
with a Technoray, with 12 attributes.
To replace a fixture, select a replacement from the fixture list box. You can use the mouse or once you click on
the list box you can use the up/down arrow keys. After selecting a fixture click OK. The fixture tree list will be
13-4
Fixture Patching