Download Installation Manual

19. To install radius Snap-On's (item #8), position as shown on drawing and tap
into place using a rubber mallet (you should hear them snapping into the angles).
20. Replace the control unit cover.
21. Ensure all anchors and attachment bolts are tight. The overall turnstile
stability must be sound and rigid.
!!! Important: Remove protective film from polycarbonate panels as soon
as possible upon completion of the installation. Prolonged exposure to
direct sunlight could cause the film to be extremely difficult to remove.
ELECTRICAL CONDUIT
All external wiring must be brought into the control mechanism assembly located
at the top of the turnstile.
Run conduit containing the necessary power and control wiring up either side of
the turnstile or along the top rail of the fence line. If the installation is indoors it is
acceptable to bring the conduit down from the ceiling.
Caution
Do not allow any metal shavings to drop on or around the controller as well as
any control and power wiring connections! Note: On the aluminum types of
turnstiles, control wiring can be brought through the hollow portions of the barrier
head assembly.
8
Rev 0103.01