Transcript
5.2 Silent Covert Pocket Vibration Mode: You can place this small gem in your pocket and when it detects eavesdropping it will alert you by silently vibrating. You will know in an instant if it detects an RF bug, cell phone bug or sends a GPS transmission. (The RF detector must be on) ANT. ANT. Off 6.2 If ten colored LED still keep lighting it means the surronding signal is very strong. ※When the detection activity is proceeded at the high floor the siganl is stronger than usaual.) Finder Viewer Blink On Signal Level Off Low Sensitivity High Sensitivity 6. Operation Hidden Camera Finder Radio Detector 20MHz – 6GHz 7 Off 2 Finder Viewer Blink On Signal Level Off Low Sensitivity High Sensitivity Hidden Camera Finder Radio Detector 20MHz – 6GHz ANT. Off 6.5 Switch View Finder 2 to On or Blink to find the hidden camera lens. 6.6 Look through the view finder from the obverse side of the device. 6.7 The hidden lens will flash when the laser LED light spot it as shown in the illustrations below. Finder Viewer Blink On ANT. 8 Signal Level Off Low Sensitivity High Sensitivity Off Finder Viewer Blink On Signal Level Off Low Sensitivity 3 High Sensitivity 6.1 Pull up the antenna and switch 3 to High Senstivity. At the time the device is on ten colored LED lights blink and it leaves 1-3 LED lighting in the detection mode. Hidden Camera Finder Radio Detector 20MHz – 6GHz 6.3 When the surronding signal is too strong it may influence the real target finding. In this situation switch the sensitivity adjustment to Low and pull back the antenna. (WiFi is also a RF signal) Hidden Camera Finder Radio Detector 20MHz – 6GHz (4) (6) 8 ANT. 1 2 Blink Signal Level 3 Finder Viewer On Signal Level Off Off High Sensitivity On 4 Blink High Sensitivity User manual Two Batteries Off 3.1 To open the back cover slide it towards the bottom of the device. 3.2 Insert the batteries as shown in the illustration. 3.3 Close the back cover by sliding it towards the top of the device. Low Sensitivity High Sensitivity 1. Vibration switch 2. Hidden camera scan Blink/On/Off 3. Sensitivity adjustment 4. Back cover Hidden Camera Finder Radio Detector 20MHz – 6GHz 5. RF signal strength colored light array 6. Laser LED lights 7. Hidden camera view finder 8. Telescoping antenna Law Enforcement Products Manufacturer LawMate V1.0 (1) 3 Low Sensitivity High Sensitivity A B C Hidden Camera Finder Radio Detector 20MHz – 6GHz 3. Power supply Signal Level Signal Level Off Hidden Camera Finder Radio Detector 20MHz – 6GHz Low Sensitivity Finder Viewer Blink Hidden Camera Finder Radio Detector 20MHz – 6GHz Finder Viewer On Manual Low Sensitivity Main device Off 1 Blink 5 Off ANT. ANT. Off 6 Finder Viewer 5. RF signal strength colored light array / Slient vibration alert mode ANT. 7 Off (7) 2. Package content 1. Name and parts On NTT DoCoMo 6 (5) RD-10 RF Detector Hidden Camera Detector Quick Guide 6.4 RF sensitivity adjustment can be used for a confirmation of irregular signal finding. Switch the sensitivity to low and apprroach to the suspected target. If the signal strength is still strong the view finder can be turned on for the final check. (2) 5.1 RF signal strength meter ten colored light array 5.1.1 Slide 3 to High/Low Sensitivity. The blue LED at the bottom of the bar lights up as shown in the illustration A. The device is on and stays at the detection mode. 5.1.2 Ten colored light array shows the output power of the target. (as shown in the illustration B) 5.1.3 When the device is low battery the blue LED turns off. (3)