Download emutel Symphony - Arca Technologies

Transcript
X.25 OPERATION
Outgoing.
TEI Value
Called Party Number
Pressing <Enter> can change the Terminal Endpoint Identifier.
As default this value is set to “1”.
When using SVCs it is necessary to send the called party number,
as the call is still using the ISDN network. However, depending
upon the Terminal Equipment being used, this may be called one
of the following.
1. Called Party Number
2. Telephone number
3. Address
Etc.
Restarts
Whenever an X25 call is being set up, a RESTART message must
be sent. Normally the DTE will do this, however, due to a
generalisation in the specification, some DTEs do not have this
capability. For this reason an option has been implemented for
the simulator to send a RESTART on Layer 2 establishment.
APPENDIX 1
97