Download JDSU / Acterna / TTC T-Berd 310 Manual

SECTION 2 - DS1/DS0 ANALYZER OPTION AUXILIARY FUNCTIONS
Introduction
DS1/DS0 ANALYZER OPTION AUXILIARY FUNCTIONS
2.75
INTRODUCTION
The following auxiliary functions configure the 310-1 DS1/DS0 Analyzer Option to transmit a user-programmable test pattern, transmit standard and programmable loop codes, transmit and report on ESF PRMs,
control the DATAPORT connector signal, customize test result printouts, measure DS1 timing slips, scan
and report on specified events, and test FT1 channels.
2.76
USER1 — USER-PROGRAMMABLE TEST PATTERN
AUX
USER1
↑ forward rev ↓
100000
↑ toggle end ↓
The AUX-USER1 auxiliary function programs a 3- to 24-bit user-programmable test pattern. This allows the
DS1/DS0 Analyzer Option to transmit specific patterns to test circuit sensitivity. The pattern is transmitted
when the USER1 pattern is selected with the PATTERN switch. The pattern is transmitted in left-to-right
order. A test restart of the DS1/DS0 Analyzer Option occurs when the pattern is saved while the USER1 pattern is transmitted. The test pattern is programmed with the following switches:
RESULTS I Results switch — Press the up arrow to move the cursor forward from left to right. Moving
the cursor forward past the last displayed bit automatically inserts a “0” in each new position up to 24
bits. Press the down arrow to move the cursor in reverse from right to left.
RESULTS II Results switch — Press the up arrow to toggle the highlighted bit between “1” and “0”.
Press the down arrow to end or save the bit pattern from the position of the cursor to the first bit on the
left. Any bits to the right of the cursor are deleted when the down arrow is pressed. The pattern is saved
when end is selected.
2.77
PGM LPUP — PROGRAMMABLE LOOP-UP CODE
AUX
PGM LPUP
↑ forward rev ↓
10000
↑ toggle end ↓
The AUX-PGM LPUP auxiliary function programs a 3- to 8-bit user-defined loop-up code. This allows the
DS1/DS0 Analyzer Option to transmit nonstandard loop codes. The programmed loop-up code is transmitted when the LOOP UP switch is pressed and the AUX-LP CODE auxiliary function is set to PROGRAMMABLE. The loop code is transmitted in left-to-right order. The loop-up code is programmed with the
following switches:
RESULTS I Results switch — Press the up arrow to move the cursor forward from left to right. Moving
the cursor forward past the last displayed bit automatically inserts a “0” in each new position up to eight
bits. Press the down arrow to move the cursor in reverse from right to left.
User’s Manual
T-BERD 310
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2-147