Download Installer manual

Transcript
Removing the cover, base board
Accessibility, electrical connection
The plastic cap of the electrical boxes is opened using a
screwdriver.
Caution
To remove the cover for the base board, the
cover for the input circuit board must first be
removed.
NOTE
The cover for the input card is opened without
a tool.
1
Removing the cover, input circuit board
1
LE
K
A
B
21
2
LE
K
1. Push the piece of plastic down.
2. Angle out the cover and remove it.
LE
K
32
Removing the cover, immersion heater circuit
board
A
1
B
1. Disconnect the switches using a screwdriver.
2. Insert the screwdriver (A) and pry the piece of plastic
carefully downwards (B).
3. Angle out the cover and remove it.
LE
K
2
1. Insert the screwdriver (A) and pry the piece of plastic
carefully downwards (B).
2. Angle out the cover and remove it.
NIBE™ F1245
Chapter 5 | Electrical connections
19