Download AutostAr

171
Figure 10-35: MFD Measurement display
This frame contains a slider where you can adjust the accuracy and it shows the actually measure MFD
value.
Measurable values. Test points below this green line can not be measured accurately enough and will treated
as invalid.
If you move the slider in the sensor 9229 frame down the green limiting line will also move down. This means
that now more inaccurate values will be allowed.
10.5 Run time control
The run time control section controls how long a complete test. Figure 10-35 shows the run time control
section.
Figure 10-36: Run time control section
This section consists of a progress bar, a test duration section, a time elapsed counter, an approximate test
time message, control buttons and an option to insert a message before running a test. For details please
refer to section 5.3.5 Running a test.