Download SY3634 - Users` Manual
Transcript
SY3634 User’s Manual Remote Control MRM Set output current value (ramp) W MRP Read DC-Link voltage value R MRT Read output stage heatsink temperature R MRTS Read regulation shunt temperature R MRV Read output voltage value R MRW Read estimated active output power value R MSP Read last stored output current setpoint R MSR Read or write slew-rate value R/W MST Read module internal status register R MUP Update all EEPROM parameters W MWAVE Set waveform total number of points W MWAVEP Set waveform single point W MWAVER Read stored waveform points R MWAVESTART Start waveform execution W MWAVESTOP Stop waveform execution W MWF Write selected EEPROM “field” cell W MWG Write selected EEPROM “value” cell W MWH Write hexadecimal raw ADC value W MWI Set output current value (no ramp) W PTP Write password to unlock passwordprotected cells Refresh digital PID regulator parameters SIP Set module IP address W VER Read module model and installed firmware versions R PASSWORD W W Table 6: A36xxBS module Command List It is important to notice that some commands are write-only commands (e.g. MRM to set output current) and some others are read-only commands (e.g. MRI to read output current value). The only command that allows reading and setting is the MSR command, which reads or sets the user-defined slew-rate for the power supply (see ‘MSR Command’ section for further details). 56