Download SY3634 - Users` Manual

Transcript
SY3634 User’s Manual
Remote Control
MRM
Set output current value (ramp)
W
MRP
Read DC-Link voltage value
R
MRT
Read output stage heatsink temperature
R
MRTS
Read regulation shunt temperature
R
MRV
Read output voltage value
R
MRW
Read estimated active output power
value
R
MSP
Read last stored output current setpoint
R
MSR
Read or write slew-rate value
R/W
MST
Read module internal status register
R
MUP
Update all EEPROM parameters
W
MWAVE
Set waveform total number of points
W
MWAVEP
Set waveform single point
W
MWAVER
Read stored waveform points
R
MWAVESTART
Start waveform execution
W
MWAVESTOP
Stop waveform execution
W
MWF
Write selected EEPROM “field” cell
W
MWG
Write selected EEPROM “value” cell
W
MWH
Write hexadecimal raw ADC value
W
MWI
Set output current value (no ramp)
W
PTP
Write password to unlock passwordprotected cells
Refresh digital PID regulator parameters
SIP
Set module IP address
W
VER
Read module model and installed
firmware versions
R
PASSWORD
W
W
Table 6: A36xxBS module Command List
It is important to notice that some commands are write-only commands (e.g.
MRM to set output current) and some others are read-only commands (e.g. MRI to
read output current value).
The only command that allows reading and setting is the MSR command, which
reads or sets the user-defined slew-rate for the power supply (see ‘MSR Command’
section for further details).
56