Download 1 Introduction to Hydro GeoBuilder

11.2.2 Defining Other Boundary Conditions
This section describes the workflow for creating the following boundary conditions:
•
•
•
•
•
•
•
•
Specified Head
River
General Head
Drain
Recharge
Evapotranspiration
Lake
Specified Flux
Note: For information on creating a Well boundary condition, please see “Defining a
Pumping Well Boundary Condition” on page 155
To create a boundary condition, follow the steps below:
• From the Conceptual Model tree, right-click on the Boundary Condition
Container node and select Add New Boundary Condition... .
Specifying Boundary Condition Type and Location
The first step involves selecting the boundary condition type and specifying the
location of the boundary condition on the simulation domain.
158
Chapter 11: Boundary Modeling