Download User Manual
Transcript
EDS800 series Service Manual Decelerating time is too Prolong decelerating time short Increase braking power of Have potential energy external energy consumption load or big inertia load braking subassembly E005 overvoltage during decelerating process E006 Accel/Decel time is set Overvoltage to too short during constant speed process Input voltage change abnormally Unwonted input voltage E007 controlpower supply overvoltage Use energy consumption subassembly Unwonted input voltage Check input power supply or look for service improper V/F curve Inverter overload Restart rotating motor power source voltage is too low E009 Motor overload Assemble reactor Load inertia is a bit big Accel time is set to too short DC injection braking is too big E008 Check input power supply Prolong accelerating decelerating time properly Prolong accelerating time Reduce DC injection braking current,prolong braking time Adjust V/F curve and torque boost Set speed checking restart function check power source voltage Load is too big Choose inverter with high-power improper V/F curve Adjust V/F curve and torque boost power source voltage is too low check power source voltage General motor run at low speed with big load Can choose frequency conversion motor for long time low speed run motor overload to set motor overload protection protection factor set factor correctly incorrectly motor blocked up or load change too suddenly and Check the load quickly To clear air-path or improve Air-path blocked ventilation condition over Ambient temperature is too Improve ventilation condition, high lower carrier frequency E010 inverter heating E011 reserved reserved reserved E012 reserved reserved reserved Fan damaged Replace the fan 104