Download Setting up Netviewer Admin

Setting up Netviewer
The Host password is saved on the Host computer only and never leaves that computer.
7.
Click Next.
8.
Optionally, you can define a proxy server if you use a proxy server to
access the Internet. Enter your proxy settings. Enter the port (usually
3128 or 8080) and the proxy server’s address (DNS name or IP address).
If necessary, contact your system administrator to get this information.
If you do not use a proxy server or are not sure, select Use automatic
proxy settings.
9.
Click Next.
10. Click Install to begin the installation; wait until installation is complete
before continuing. Netviewer Admin Host will now be installed and
started as a System Service on the Host computer. The Netviewer
Admin Host icon will appear in the system tray.
11.
Click Finish to exit the installation wizard.
If you made the correct entries in the installation wizard, you can now use the
Master program and the corresponding optional Host password to access the Host
computer.
If the license key you entered in the installation wizard was not correct, at the end of the
installation, the Admin Host Settings dialog opens to the License key tab. You can re-enter
the license key here.
Netviewer Admin
4