Download Adept MV Controller User`s Guide

Connecting AC Power
Power Entry Module
The power entry module is located at the lower left side of the controller front panel. It
contains:
• the On/Off power switch (
I = On,
o = Off)
• the AC power cord socket
• the two incoming AC line fuses
adept
technology, inc.
WARNING: FOR CONTINUED
PROTECTION AGAINST RISK OF
FIRE, REPLACE ONLY WITH SAME
TYPE AND RATING OF FUSE.
Figure 4-1. Power Entry Module
Connecting AC Power Cord
The AC power cord is included in the accessory kit. The controller end of the power cord
is fitted with an IEC 320 connector. The user end of the cord is unterminated. Connect
each conductor of the power cord securely to your AC power source, using the color code
below. You must provide a suitable plug or other facility connection in accordance with all
applicable local and national codes. See the next section for important information on
system grounding.
Table 4-3. Power Cord Specifications
Cord length
3 meters ±0.1 m (9 ft. 10 in. ±4 in.)
Cord rating
10 amps
Number and size of
conductors
3 x 1.00 mm2
Color code
line
neutral
ground
brown
blue
green/yellow
Adept MV Controller User’s Guide, Rev C
47