Download RC4 System User Manual

Transcript
Getting Started – Setting Up RC4 Components
Items You Do NOT Need to Get Started
RC4 systems may ship with some extra items that are not needed to get started,
including:




12VDC power adaptor
Short 25-pin D-Sub data adaptor cable
Short data adaptor for use with MINI receivers
Various extra connector shells, pins, etc.
Put these items in a safe place where they can be found in the future. More
information about the power and data adaptors can be found in the Radio Settings
section of this manual. If your have not received these items, don’t worry – they are
readily available if you need them in the future.
Parts of the RC4 System
The RC4 system consists of a rack-mount transmitter, transmitter transceiver, and one or more
receiver/dimmers. Before the system can be used, each item must be properly set up and connected.
Transmitter
The FlexTX transmitter, the top-off-the-line model in the RC4-TXD-Series, is a 4-inch deep 3U rack
chassis. Control signals are sent to a remote spread-spectrum radio transceiver via a supplied 25-pin D-Sub
cable, and this transceiver communicates with radio-dimmers on stage. The 25-pin cable carries both
power and data to the transceiver. Connect the rack chassis to the transceiver with this cable, and position
the transceiver so the top surface is facing towards the receiver/dimmers (usually towards the theater stage).
The transceiver antenna is under the top surface of the case, as indicated on the transceiver label.
No AC adaptor is required to power the transceiver – it is powered by the D-Sub data cable.
The spread-spectrum radios of the RC4 system will work through walls and other barriers to a distance of
several hundred feet. This range will be reduced, however, by the density of obstructions, other radio
activity in the 907 - 921Mhz band, and wide-band interference generated by nearby lamps, motors, etc.
(including loads connected to RC4 receivers themselves). Line-of-sight from the transmitter transceiver to
each RX4 receiver is great where possible, but is not essential.
The FlexTX includes a World-Voltage switching power supply that will operate safely with input
voltage from 85VAC to 265VAC, 47 to 440Hz.
Soundsculpture RC4 Operation Manual
Page 5 of 43