Download TrafficShield Installation and Configuration Manual

Chapter 4
HTTP Settings
Use this section if the web application can be accessed using HTTP.
Enter the following information:
Use HTTP
To allow HTTP access to the web application, select this option and enter
the information described below.
Important
You need to configure at least one protocol: HTTP or HTTPS (next step).
Service Port
Specify the service port.
Web Server IP, Web Server Port
Specify the web server's IP address and port. The address is used for
communications with the TrafficShield Application Firewall.
Max. Sessions
Specify the maximum number of simultaneous sessions TrafficShield
Application Firewall can open in its interactions with the web server. The
number of sessions that can be opened, and therefore the number of visitors
that can be served simultaneously depends on the capacity of the web server.
Note
“The number of visitors that can be served simultaneously” mentioned
above, refers to the actual number of established connections, while in
reality there is a greater number of connections in the process being
established or being closed. The maximum session should reflect the total of
all three session statuses.
Tip
If you are not familiar with your server configuration, you need to consult
with your system administrator about the maximum number of simultaneous
clients and connection time-out definitions.
Verification Object
This optional field enables the user to verify that the TrafficShield
Application Firewall is responding correctly to a pre-defined test object.
4 - 14