Download PN200 Hand Controller Install & Use Manual

If you get the screen as shown, proceed to the next step by hitting the FINISH
button.
IF YOU HAVE A RED X next to either Driver Name OR the Status is NOT “Ready to
Use” your USB driver install has failed. You will not be able to use your PN200.
Possible failures can be from a version of XP without at least SP2 installed or from
a hardware issue with the USB ports on the PC. Select Cancel and stop the install.
Make any upgrades you need and try again. If the install fails at this point again
please contact us via e-mail ([email protected]) or on the Support Forum (Yahoo
Forum).
Page10