Download Eos X Terminal user`s manual

3. Getting started
3.2.9 Dual RGB Input Card
The DUAL RGB INPUT CARD provides the capability of displaying RGB monitor signals. Either two analog signals up to
1280×1024@75Hz or one analog signal up to UXGA resolution or higher are digitized for further processing in EOS.
Standard
The synchronization modes Hsync+Vsync, Csync and Sync-on-Green are supported.
Connectors
The DUAL RGB INPUT CARD has two VGA compatible 15-pin SubMinD connectors. Each is for connecting one RGB
signal to the OMNIBUS. If an UXGA signal is inserted it must be connected to RGB In 1, while RGB In 2 is not available.
RGB In 1
RGB In 2
Figure 3-31
connector of DUAL RGB INPUT CARD
Order
Within a single DUAL RGB INPUT CARD the numbering of the video channels is as shown in the figure above. The
order of the DUAL RGB INPUT CARDS in EOS is determined in exactly the same way as with the QUAD ANALOG VIDEO
CARD. Refer to section 3.2.7 Quad Analog Video Card, please.
Specifications
For detailed technical specifications of the DUAL RGB INPUT CARD please refer to section 7.1 Technical data.
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 12 – February-2005
______________________________________________________________________
3-22