Download vfmc-1000-ptc series m - Motion Control Engineering, Inc.

5.4.4.18.2 MOMENT D.O.B. FOR: (HALL CALLS/ CAR CALLS/ ALL CALLS) - Choose
whether hall calls, car calls or all calls need momentary D.O.B.
C
HALL CALLS - this option necessitates that DOB be pressed when the car
responds to hall calls. Car calls are not affected.
C
CAR CALLS - this option necessitates that DOB be pressed when the car
responds to car calls. Hall calls are not affected.
C
ALL CALLS - this option necessitates that DOB be pressed when the car
responds to both hall calls and car calls.
5.4.4.19 DOORS TO OPEN IF PARKED: - (NONE/FRONT/REAR/BOTH) If set to NONE, the
doors remain closed while the car is parked. When set to FRONT, REAR, or BOTH, the
corresponding doors automatically open and remain open while the car is parked. This option
is available only if a parking floor is programmed in the Basic Features menu. BOTH option
is not available if the car is programmed for sequential door operation. See Section 5.4.4.3 for
more details.
5.4.4.20 DOORS TO OPEN ON MAIN FIRE? - The choices for this option are FRONT, REAR
and BOTH. This option determines which door(s) should open once the car has completed a
Main Fire return (only if option 5.4.2.4 is set to YES).
5.4.4.21 DOORS TO OPEN ON ALT FIRE? - The choices for this option are FRONT, REAR
and BOTH. This option determines which door(s) should open once the car has completed an
Alternate Fire return (only if option 5.4.2.4 is set to YES).
5.4.4.22 LEAVE DOORS OPEN ON CTL? - When set to YES, and the CTL (car to lobby) input
is active, once the car returns to the lobby, the doors will remain open instead of cycling closed.
5.4.4.23 LIMITED DOOR RE-OPEN OPTION - Once the doors begin to close after a door
dwell time has expired, if a re-opening device input (PHE or SE) is seen, this option will allow
the doors to re-open as long as the re-opening device is active. Once the re-opening device
is inactive, the doors will immediately begin to close again. Without this option set, in this same
case, the doors will re-open fully for a short door time and then close.
5.4.4.24 REDUCE HCT WITH PHOTO EYE - This option will cause a normal hall call time to
be shortened to a short door time if a photo eye input is seen.
5.4.4.25 LEAVE DOORS OPEN ON EPI - When set to YES, and EPI (Emergency Power)
input is active, once the car returns to the emergency power return floor, the doors are left open
instead of cycling closed.
5.4.4.26 DOORS TO OPEN IF NO DEMAND - (NONE/FRONT/REAR/BOTH) - When set to
NONE, the doors remain closed when the car is at a landing with no demand. When set to
FRONT, REAR, or BOTH, the corresponding doors automatically open and remain open when
the car is at a landing with no demand. BOTH option is not available if the car is programmed
for sequential door operation. See Section 5.4.4.3 for more details
5.4.4.27 CONST. PRESS OP. BYPASS PHE? - This option is used to indicate if Constant
Pressure Operations, such as Independent Service, Attendant Service, or if the Constant
Pressure Door Close option is set to YES, should bypass the Photo Eye when the Photo Eye
is active and there is a demand to close the doors and move the car. When set to YES, the car
will bypass the Photo Eye and nudge the doors closed. When set to NO, the car will not bypass
the Photo Eye; the doors will remain open until the Photo Eye is cleared.
5-28
•
THE COMPUTER
Software Revision 6.03