Download ST2819 user manual

ST2819A Operation Manual
<LI MI T TABLE SETUP>
MEAS SETUP
CORRECTI ON
LI MI T TABLE
LI ST SETUP
MORE 2/ 3
PARAM
COMP
SWAP PARAM
TOOLS
FI LE
FI LE Manage
LOW
HI GH
CLEAR TABLE
ESC
MODE
% TOL
ABS TOL
SEQ MODE
NOM[ NUMERI C ENTRY]
ON
OFF
LOAD
STORE
DEL
AUX
ON
OFF
p
n
μ
m
MORE 1/ 2
k
M
*1
p
n
μ
m
MORE 1/ 2
k
M
*1
MORE 2/ 2
CLEAR LI NE
[ NUMERI C ENTRY]
MORE 2/ 2
Figure 3-17 Available Softkeys on the LIMIT TABLE SETUP Page
3.8.1
Swap Parameter
The swap parameter function is used to swap the primary parameter for the secondary parameter in
the PARAM field. For example, when the measurement function is Cp-D, the swap parameter function
sets the measurement function to D-Cp. Then the comparison limits for D are a maximum of nine pairs of
comparison limits, and the comparison limits for Cp are one pair now.
Front Panel Operation for Swapping the Primary Parameter for the Secondary Parameter
Perform the following steps to swap the primary parameter for the secondary parameter.
1)
Move the cursor to the PARAM field. The following softkey will be displayed.
■ SWAP PARAM
63