Download TEK 3066, 3086 Sony Programming
Transcript
Getting Started Connecting the Interface The analyzer has an IBM PC based expansion slots on its rear panel, as shown in Figure 1–5. The analyzer is shipped standard with a GPIB port. In addition, the analyzer can be configured with optional networking cards. H GPIB interface This connector has a D-type shell and conforms to IEEE Std 488.1–1987 (The cable is available from Tektronix as part number 012–0991–00). H Ethernet interface (Option 10) With Option 10, you can connect the analyzer directly to an Ethernet network using a twisted pair (10BASE-T/100BASE-TX) cable. NOTE. Only a service personnel can install the network card. Contact Tektronix for details. You can also connect the following peripheral devices to the analyzer. Refer to the 3066 and 3086 User Manual for information on using these interfaces. H Mouse and keyboard interface H Parallel interface for connecting a printer H SCSI interface for connecting a SCSI device such as an hard disk. Parallel connector SCSI connector Ethernet interface (Option 10) GPIB interface Mouse and keyboard interface Figure 1-5: Interface connector location on the rear panel 1-4 3066 & 3086 3 GHz Real Time Spectrum Analyzer Programmer Manual
Related documents
User Manual WCA330 & WCA380 3GHz & 8GHz Wireless
Chapter 1
Sensor Based Robot Control - DTU Electronic Theses and
Yamaha DTXM12 user manual
Owner`s Manual
Audiovox CE151MP User's Manual
Canon MS-800 User's Manual
Canon Microfilm Scanner 350 Owner's Manual
IDIAP R ESEARCH R EPOR T
Proxim ORiNOCO AP-8000 User guide
Cannon 300II Photo Scanner User Manual
Canon 350II User's Manual