Download Model SMA7215

CHAPTER 1: DESCRIPTION, FEATURES AND SPECIFICATIONS
1.3 Specifications:
The amplifier module requires an external DC power supply which must include a bridge
rectifier, buss capacitor, solid-state relay and shunt regulator. Forced air cooling is required to
meet the maximum power ratings specified below.
1.3.1 Input and Output Power:
•
•
Buss Voltage, B+:
Output Power:
24-220VDC.
15A(continuous), 25A(peak).
20A(continuous), 40A(peak).
Standard
High Power
1.3.2 Signal Inputs:
Signal Input
Single-ended
Voltage
VDC
(maximum)
+/-70
Impedance
(minimum)
Ω
10,000
+/-90
10,000
Tachometer input
Velocity Gain Current Gain
Amp./Volt
Amp./Volt
15,000
0-5
7,000
1.3.3 Digital Inputs:
•
•
•
+/-Limit, Clamp and Reset:
Fault (as input):
Typical for all digital inputs:
+/-50V max. Terminated by 10,000Ω.
+40V/-5V max. Terminated by 10,000Ω.
Digital inputs have hysteresis with thresholds at
1/3 and 2/3 of +5V or +15V depending on
range
select dip-switch.
1.3.4 System:
•
•
•
•
•
Drift offset over temperature reference to input:
Frequency response (Velocity loop):
Frequency response (Current loop):
Dead band:
Form factor:
0.01mV/ o C max.
750Hz min.
2KHz min.
None.
1.01.
1.3.5 Outputs:
•
Fault (as output):
•
•
Motor current:
LS/ECB, HS/ECB
Overvolt, Overtemp:
Active low. Open-collector output can sink 100mA
maximum through 10Ω.
Bipolar output. 1V=5A.
Open-collector outputs can sink 40mA max.
1.3.6 Mechanical:
Dimensions L x W x H (inches): 7.12 x 1.36 x 4.79
Weight (lbs):
1.28
GLENTEK Inc. 208 Standard Street, El Segundo, California 90245, U.S.A. (310) 322-3026
8