Download Model XMT868

June 2003
The GLOBL-SYSTM
Sub-Menu
While completing these instructions, refer to the menu map in Figure
A-4 on page A-4 in Appendix A, Menu Maps. To enter this sub-menu,
press [F1] at the Global PROGRAM prompt shown on the previous
page.
METER MESSAGE
current message appears here
F1
F2
F3
GGGG
SYSTEM UNITS
previous selection appears here
ENG
METRC
F1
F2
Key in the desired METER
MESSAGE (up to 21
characters) and press [ENT].
Press [F1] to display
parameters and measurements
in English units or press [F2]
to display parameters and
measurements in metric units.
F3
For single-channel units, the meter exits the SYSTM sub-menu and
returns to the Global PROGRAM prompt shown on the previous page.
To leave the User Program, press the [EXIT] key twice.
For 2-channel units, proceed to the following prompt.
GGG|
VOLUMETRIC UNITS
current selection appears here
GAL/S
GAL/M
Press [F1]-[F3] to select the
desired volumetric units for
the flow rate display.
GAL/H
GGG|
VOLUMETRIC UNITS
current selection appears here
MGD
ft3/s
ft3/m
F1
F2
F3
Use the [ ] and [ ] keys to
access the additional choices
shown.
The abbreviations and definitions of all the available volumetric and
totalizer units are shown in Table 1-12 on page 1-53.
1-52
Programming Site Data