Download - Permobil

Batteries
Batteries
Removing the rear battery
1. Place the wheelchair on a level surface.
A
2. Switch off the main power switch on the control panel.
C
3. Remove the rear chassis cover. See page 9.
4. Remove the output stage bracket by first loosening the two screws (A) and then lifting the
bracket straight up while turning it upside
down. Then turn the bracket to the side and
place it on the left.

B
A. The output stage bracket is fitted using two
screws.
B. The cable between the chassis and the output
stage bracket must not be disconnected.
C. The lower section of the output stage bracket is
fitted inside the rear edge of the chassis.
WARNING
The cable (B) that is fixed between the chassis and the output stage bracket reduces the risk of short-circuit and must
not be disconnected.
5. Lift/pull the battery a little way out of the chassis and disconnect the battery connections.
See also the sticker on the inside of the rear
chassis cover.
Be careful when using metal objects when working with batteries. A short-circuit can easily cause an explosion. Always
use safety gloves and safety goggles.
Lift/pull the battery a little way out of the chassis
and disconnect the battery connections.
6. Lift/pull the battery out of the chassis using the
battery belt.
Assembly
1. Lift a new battery into the chassis using the
battery belt. Leave the battery belt on the battery. Position the battery with the battery terminals at the rear.
2. Connect the battery connections on the new
battery.
3. Refit the output stage bracket. Its lower section should be fitted inside the rear edge of the
chassis (C). See the illustration above.
Battery removed.
4. Refit the chassis covers
11