Download - Permobil

Lights
Lights
(accessories)
Removing the front lights
1. Switch off the main power switch on the control panel.
2. Remove the front and upper chassis cover.
See pages 8–9.
3. Divide the lights’ cabling at the contact on the
cabling. This is loose on the inside of the chassis, over the rear battery.
4. Cut off the cable ties holding the cabling in
place. Note the positions of the cable ties for
subsequent fitting.
The contact on the front light cabling.
5. Remove the two screws that hold each of the
lights in place. These are on top of the link
arm. See the illustration.
Assembly
Assemble in the reverse order.
The front lights are fixed in place with two screws
on each link arm.
Adjustment of front lights
1. Loosen the lower screw on the side of the light
(see illustration).
2. Adjust the angle of the light so the beam is at
a suitable height.
3. Lock it at this position by retightening the
screw on the side of the light.
Adjusting the angle of the light
42