Download Section XI - Transmission

Transcript
CHBYSLER SERVICE MANUAL
308—TRANSMISSION
i
**4
j^'
—
v
-"
56x633
Fig. 101—Removal a n d Installation of Output Shaft
Drive Housing S n a p Ring
rear o i l pump m a t i n g surface f o r b u r r s and
score marks. Check f o r stripped threads i n
support. Inspect gasket surfaces f o r b u r r s and
d i r t . Inspect inside bearing surface f o r wear
and scoring.
75. DISASSEMBLY, INSPECTION AND
ASSEMBLY OF POWER TRAIN UNITS
Unit No. 1 (Output Shaft, Kickdown Planet Pinion Carrier, and Intermediate Shaft Assemblies )
—Disassembly.
U n i t can be placed i n the propeller flange and
brake d r u m assembly to aid i n disassembly,
as shown i n F i g u r e 100. U s i n g a screw driver,
remove output shaft drive housing snap r i n g ,
as shown i n F i g u r e 101. Refer to F i g . 102 and
Fig.
complete disassembly of u n i t as f o l l o w s : Remove reverse annulus gear (B) f r o m output
shaft assembly ( J ) . Remove intermediate shaft
( C ) and kickdown carrier assemblies ( E ) f r o m
output shaft assembly. Remove output shaft
t h r u s t washer ( D ) located inside of housing.
Remove kickdown planet pinion c a r r i e r assembly ( E ) f r o m intermediate shaft assembly ( C ) .
The kickdown planet pinion carrier assembly
used in this unit is identical to the low-reverse
planet p i n i o n ^carrier assembly used in Unit No.
2 but should not be interchanged. Remove kickdown c a r r i e r t h r u s t washer ( F ) f r o m c a r r i e r
assembly ( E ) . Remove sun gear roller t h r u s t
washer ( G ) f r o m intermediate shaft assembly.
W i t h a screw d r i v e r , remove kickdown annulus
gear snap r i n g ( H ) and separate gear ( I ) f r o m
intermediate shaft assembly ( C ) .
76.
OUTPUT SHAFT—INSPECTION
Inspect speedometer drive gear f o r any nicks
or burrs. A n y nick or b u r r on gear surface can
be removed w i t h the use of a sharp edged stone.
Inspect t h r u s t surfaces, journals, and inner
bushing f o r scores or excessive wear. Inspect
r i v e t i n g and housing f o r any cracks and i n t e r n a l d r i v i n g lugs f o r excessive wear. Housing and output shaft is serviced as an assembly.
Inspect interlocking seal rings ( K — L ) on
output shaft ( J ) f o r wear or broken locks, and
make sure they t u r n freely i n the grooves. Do
102—Unit No. 1 (Disassembled View)