Download Section XI - Transmission

Transcript
CHRYSLER SERVICE MANUAL
TRANSMISSION—321
TOOL
KICKDOWN I
PISTON ROD i
\
l£
u , D E
- KICKDOWN
- PISTON SPRING
• -KICKDOWN
PISTON ROD
v ^ 6 W - R E V E R S E SERVOl
\W' SPRING RETAINER
56x625
Fig. 124—Removal a n d installation of Kickdown
Piston Rod Guide and Spring
Place the kickdown piston rod guide over
spring and compress spring until piston rod
enters piston rod guide, as shown i n Figure
124. Using extreme care, compress the kickdown piston spring to the point that piston rod
guide seal r i n g slightly binds on case. Then
work seal r i n g into position by gradually compressing spring. Install snap r i n g and make
sure i t is properly seated, as shown in Figure
86. Loosen compressing portion of tool and
remove.
113. REVERSE SERVO PISTON—
INSTALLATION
Lubricate the low reverse servo piston seal r i n g
and install on piston ( l i p of seal facing end of
piston). Install cushion spring and plug into
servo piston and secure w i t h snap ring. (Make
sure snap r i n g seats properly). Install piston
assembly into transmission case.
Place reverse servo piston spring over piston
and position spring retainer over spring. I n stall Tool C-3429 or C-3489 (modified) for reverse servo piston installation. Compress spring
( F i g . 125) sufficiently to install snap ring.
Spring retainer may require guiding into case.
Make sure snap r i n g seats properly. Loosen
compressing portion of tool and remove from
transmission case.
SPRING
"~ -56x623
Fig. 125—Compressing Low and Reverse Servo
Spring and Retainer
114. IICKDOWN BAND—INSTALLATION
Install the kickdown band assembly by rotating
band ends over center support i n transmission
case, as shown i n Figure 82. Use extreme care
when installing bands so not to damage lining
on edges of transmission case. Install anchor
on kickdown band adjusting screw.
115. LOW-REVERSE BAND—INSTALLATION
Install anchor on reverse band adjusting screw.
Install band by rotating band ends through
rear opening i n transmission case, as shown
i n Figure 80.
116. LOW-REVERSE AND KICKDOWN BAND
LEVER ASSEMBLIES AND STRUTSINSTALLATION
Place levers i n position i n case and slide shaft
through levers from rear of transmission case,
as shown i n Figure 83. Remove guide stud,
Tool C-3288 from threading end of shaft and
install shaft lever spacer (flat) and plug.
Tighten plug from 30 to 35 foot-pounds. Position kickdown band over anchor and compress
band i n sufficiently to install kickdown band
strut, as shown i n Figure 81. Then place lowreverse band into position on anchor and compress band end; and w i t h the aid of a screw
driver, install strut.