Download Section XI - Transmission

Transcript
252—TRANSMISSION
CHRYSLER SERVICE MANUAL
LOW AND REVERSE
GEARSHIFT LEVER
BEARING
DRIVE PINION
Fig.
11—Positioning O i l Slinger
CAUTION
Remove the } 4 to % inch n u t f r o m synchronizer clutch gear sleeve and inner stop ring ( I f
not done so previously). Guide drive pinion
shaft t h r o u g h f r o n t of case, engaging synchronizer outer stop r i n g w i t h clutch gear on drive
pinion. Pinion shaft bearing is fully seated
when snap r i n g makes f u l l contact w i t h face
of transmission case.
Slide pinion bearing retainer over pinion
shaft and against transmission case. While
holding retainer w i t h hand pressure against
transmission case, measure the clearance between retainer and case, using a feeler gauge.
Select a gasket about .005 inch thicker (consult parts catalog f o r sizes) than the clearance (to eliminate end play on f r o n t bearing)
and install retainer and tighten bolts.
Remove transmission assembly f r o m mounti n g fixture and t i g h t e n bearing retainer screws
to 15 foot-pounds torque and extension to case
bolts 30 foot-pounds torque. Install mainshaft
washer (convex side towards n u t ) and d r a w
Fig. 12—Installing Interlock Sleeve
57 X 4 9 6
l
J
Fig. 13—Depressing Interlock Ball—Using
Suggested Tool
nut up snug against washer. I n s t a l l lubricant
d r a i n plug and tighten 20 foot-pounds torque.
e. Gearshift Housing (Refer to Fig. 1)
Place gearshift housing i n vise (equipped w i t h
soft j a w s ) ( F i g . 1 2 ) . Place " 0 " r i n g seal on
second and direct gearshift lever shaft and i n stall lever shaft i n housing. Secure shaft i n
place w i t h r e t a i n i n g p i n . Install interlock sleeve
i n its bore, as shown i n F i g u r e 12. Place one
of the interlock balls i n sleeve followed by i n terlock ball spring, and p i n .
Place low and reverse gearshift lever shaft
( p a r t w a y ) into its bore after installing " O "
r i n g seal on shaft. Place second interlock ball
on top of interlock ball spring. While depressing
ball w i t h the suggested tool, as shown i n F i g ure 13, rotate tool 90° and engage w i t h low
and reverse gearshift lever cam by completely
seating shaft i n bore while allowing interlock
ball to seat i n detent of lever, as shown i n
F i g u r e 14.
N O T E : A suggested tool for depressing and engaging the interlock ball consists of bending
and finishing a piece of *4 inch drill rod, as
shown in the section accompaning Figure 13.