Download Manual - Henry Tools

This tool is designed
to operate on 90 psig
(6.2 bar) maximum
air pressure with 1/4”
(8 mm) hose. Do not
use a grinder without
recommended wheel
guard. Do not use any
wheel for which the
operating speed listed
is lower than the actual free speed of the
Grinder.
SAFETY
1. Before operation
check spindle speed
with a tachometer. If
the RPM exceeds the
rated speed stamped
on tool, servicing is
required.
2. Inspect grinding
wheels for bends,
chips, nicks, cracks
or severe wear. If
the wheel has any of
these, or has been
soaked in liquids do
not use. On brushes
check for loose wires
that may fly off in
operation.
3. Start new grinding
wheels under a steel
bench. Run at full
throttle for one minute. Defective wheels
usually come apart
immediately. When
starting a cold wheel
apply to work slowly,
allow wheel to warm
gradually.
4. Model 48RAC
grinders equipped
with collets are intended for mounted
www.HenryTools.com | Page 100
For additional product information visit our website.
Revised 02/19/12
Ph:
MODELS
48 RA
48 BRA2
48 BRA4
48 BRAD
48 RAS
48 RAZ
48 RAD
48 RAC
HENRY TOOLS, INC. (216) 291-1011 or (800) 826-5257
General Operators Instructions and Service Manual