Download SECTION 5: Troubleshooting

SECTION 3: Vender Programming
be modified. Pressing <up> or <down> will increase
or decrease the minutes value. Pressing <enter> again
will save the displayed setting and return you to the
“Stop Hour” prompt. Pressing <exit> while in editing
mode will return the controller to the “Stop Hour”
prompt without saving changes.
•
32
Blocked Selections
If <enter> is pressed at the “Blocked Selections”
prompt, the controller will display “All Selections
X,” where “X” indicates whether all selections will
be blocked or not. Using <up> or <down> will allow
you to cycle through each individual selection. If
<enter> is pressed at “Block Selection N X,” the
display will flash “X” (block status) for the displayed
selection. Pressing <up> or <down> will toggle “X”
between “1” (enabled) or “0” (disabled). When the
desired setting is on the display, pressing <enter>
will save the setting and return to the selection level,
where the block status no longer flashes. If the “All
Selections X” is set and saved, all the selections will
be set at once. Use <exit> to return to the “Blocked
Selections” prompt. From the “Blocked Selections”
prompt, use <exit> to return to the “Selection Blocking X” prompt.
Set Time / Date
If <enter> is pressed at the “Set Time / Date” prompt, the
controller will enter the current time setting mode by displaying “Year.” Using <up> or <down> will allow you to
cycle through all available time setting options. If <exit>
is pressed anytime during this operation, the controller
will return to the “Set Time / Date” prompt. Use <up> to
proceed to the next prompt, “Refrigeration.”
•
Year
If <enter> is pressed at the “Year” prompt, the current
year setting is displayed and will be flashing. Pressing
<up> or <down> at this point will increase or decrease the year setting. Pressing <enter> will save the
displayed year setting and return you to the “YEAR”
prompt. Use <up> to proceed to the next prompt,
“Month.”
•
Month
If <enter> is pressed at the “Month” prompt, the current month setting is displayed and will be flashing.
Pressing <up> or <down> at this point will increase
or decrease the month setting. Pressing <enter> will
save the displayed month setting and return you to the
“Month” prompt. Use <up> to proceed to the next
prompt, “Date.”
•
Date
If <enter> is pressed at the “Date” prompt, the current two digit date-of-the-month setting (01-31) is
displayed. Pressing <up> or <down> at this point
will increase or decrease this number. If <enter> is
pressed, the currently displayed date is saved and the
controller will return to the “Date” prompt. Use <up>
to proceed to the next prompt, “Hour.”
•
Hour
If <enter> is pressed at the “Hour” prompt, the current
time is displayed in a 24-hour format. The left two
digits of the display show the current hour setting; the
right two digits show the current minutes. The hour
setting will be flashing. Pressing <up> or <down> at
this point will increase or decrease the hour setting.
If <enter> is pressed, the minute setting will flash.
Pressing <up> or <down> at this point will increase or
decrease the minutes setting. Pressing <enter> again
will save the displayed hour and minutes setting and
return you to the “Hour” prompt. Pressing <exit>
while in editing mode will return you to the “Hour”
prompt without saving changes. Use <up> to proceed
to the next prompt, “Daylight Savings.”
Royal Vision Vender NG 230 VAC 50 Hz Five-Button Service and Parts Manual