Download SECTION 5: Troubleshooting

SECTION 3: Vender Programming
External Menu
Access the External Menu by entering your 4-digit password when the main door is closed (see “Preview Password” in the “Internal [Service] Menu” section).
Note: In the External Menu, the <clear> button will have
no function. Sales counters can not be reset and error
codes can not be cleared in the External Menu.
Sales Counters
If the external preview password is correctly entered, the
display will show “Sales Counters.” If <enter> is pressed
at the “Sales Counters” prompt, the controller will enter
the non-resettable sale count display mode displaying
“Sales Total XXX,” where the X’s represent the number of
all paid vends over the life of the vender’s control board.
Using <up> or <down> will cycle through each selection
as “Sales Sel N XXX,” where “N” represents the appropriate selection number and the X’s represent the number of
vends for that selection. If <exit> is pressed anytime during this operation, the controller will return to the “Sales
Counters” prompt. Press the <up> button to proceed to the
next prompt, “Error Codes.”
Error Codes
If <enter> is pressed at the “Error Codes” prompt, the controller will enter the error display mode. If no errors have
occurred since the last error reset, the display will show
“None.” If an error has been detected since the last error
reset, the display will show the first summary error code
that has occurred, such as “Vend,” which would indicate
a vend error. Pressing <up> or <down> will allow you to
cycle through all of the summary error codes that are present. Pressing <enter> at the displayed summary error code
will allow you to view the detailed error codes beneath the
summary error heading. Pressing <up> or <down> at this
point will allow you to cycle through all of the detailed
error codes that are present beneath the summary error
code. If the <exit> button is pressed at anytime during this
operation, the controller will return to the “Error Codes”
prompt. Press the <up> button to proceed to the next
prompt, “Return to Sales.”
For further details on reading error codes, see “Error
Codes” in the “Internal [Service] Menu” section.
Return to Sales
If <enter> is pressed at the “Return to Sales” prompt, the
controller will return to the sales mode.
Royal Vision Vender NG 230 VAC 50 Hz Five-Button Service and Parts Manual
39