Download Removing the generator cover

Transcript
Flywheel - generator
11 of 12
file:///C:/Users/PKM/Desktop/Peter/Hypermotard Service Manual/Work...
Ref
Qty.
Description
10
8
M6x25 mm screws
11
2
M6x20 mm screws
12
3
M6x30 mm screws
Tighten the retaining screws to the specified torque (Sect. C 3, Engine torque settings).
Fit the washer (14) and the tube guide (15) under the screw (12), close to the starter motor.
Tighten the retaining screws to the specified torque (Sect. C 3, Engine torque settings).
Dampen oil seal (3) with alcohol and fit it on the generator cover, at the gear change lever shaft.
Apply grease to the screws (6).
Tighten the two screws (6), securing cover (5) at the crankshaft, to the specified torque (Sect. C 3, Engine torque
settings).
4/29/2013 6:49 PM