Download Removing the generator cover

Flywheel - generator
6 of 12
file:///C:/Users/PKM/Desktop/Peter/Hypermotard Service Manual/Work...
Caution
Check inner ring (32), needle roller bearing (34) and inner washer (35) for wear.
Note
The inner ring (32) has an oil drilling for needle roller bearing (34) lubrication.
Checking the flywheel - generator assembly
Check that the generator rotor (23) inner part is not damaged.
Check that the starter clutch is working properly and that the needle races do not show signs of wear or damage of
any kind.
In the event of defects, dismantle the assembly.
Disassembling the flywheel - generator assembly
Undo the eight screws (26) and remove rotor (23) from flywheel.
Slide out reference pin (28) and circlip (27).
Start two of the screws (26), just removed from flywheel rotor-side, into their holes in order to remove flange (30)
and starter clutch (31).
4/29/2013 6:49 PM