1
Download Section 1 Introduction
Transcript
Stride Belt Replacement Tools Required: Phillips head screwdriver 7/16-in. socket or open-end wrench 1/2-in. socket wrench 1/2-in. open-end wrench 3/16-in. Allen wrench 1/8-in. Allen wrench Needle nose pliers NOTE: Remove and install ONL Y ONE stride belt at a time. Remove the rear shroud: 1. Using Phillips head screwdriver, remove the eight Phillips head screws from the rear shroud. 2. Lift the rear shroud off the unit. Remove the stride belt: 1. Using needle nose pliers, CAREFULLY pull the two cotter pins out from the belt tension pulley (at the rear of the unit). 2. Using needle nose pliers, CAREFULLY pull the belt tension anchor pin out from the belt tension pulley. See Diagram R. ---- --.. '\ \ ,/ \ I \ I '" REMOVE/ " 5.20 / " ............ ~ ---- ...-/"'"' "' Diag. R Elliptical -Edge Service Manual
