Download E5100A/E5100B User`s Guide

6. Reference Level
Displays the value of a reference line in Cartesian formats. It is
selected using SCALE MENU under the 4Display5 key. However, the
reference line is invisible (it is indicated by a small triangle adjacent
to the graticule at the left).
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
7. Marker Data Readout
Displays the values of the marker in units appropriate to the current
measurement.
8. Marker Stimulus
9. Trace number
10. Service Notation
11. Stimulus Value
12. Sweep Notations
Displays the stimulus value of the marker.
Indicates the trace number for the measurement trace.
Indicates the analyzer is in service mode or self test was failed. See
E5100A/B Service Manual
Displays the start/stop or the center/span values of frequency or
power.
Displays one of the following the sweep conditions:
Hld
Ext
"
*
13. Reference Position
14. Status Notations
FFFFFFFFFFFF
Hold sweep ( HOLD under the 4Trigger5 key).
Wait external trigger ( TRIG EVENT under the 4Trigger5 key).
Under sweep
Stimulus parameters changed: measured data in doubt until a complete
fressh sweep has been taken.
FFFFFFFFFFFFFFFFFFFFFFFFFF
Indicates the reference position.
Displays the current status of various functions for each channels.
The following notations are used:
Cor
C?
C!
Del
Smo
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
Error correction is on ( Correction on OFF under the 4Cal5 key).
Stimulus parameters have changed, and interpolated error correction is
on.
Stimulus parameters have changed, and interpolated error correction is
not available.
Electrical delay or phase oset has been added or subtracted
( SCALE MENU under the 4Display5 key).
Trace smoothing is on ( SMOOTHING on OFF under the 4Display5 key).
FFFFFFFFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
For example, the upper Cor in Figure 2-2 is for channel 1 and the
lower one is for channel 2.
Front and Rear Panel
2-5