Download Module 3 PGMFI Flash Type Diagnostic Trouble Codes

Transcript
Page
3-4
Visit Our Website: www.tech2tech.net
All the 2-pin SCSs can be jumpered by using a wire, and the later systems have a
SCS tool available from Honda. The Honda SCS tool that works on all late model
systems is part # 07PAZ-0010100 and retails for $3.75 (shown in Image 3-2).
3.4.3 Read at MIL / SCS Located in OBD-II Connector
Image 3-3 SCS 16-Pin Jump Pins
On the 1998 and up Accords the SCS
was moved from a separate 2-pin connector to the 16-pin OBD-II DLC. SAE
only defines a few of the 16 pins and
the manufacturers, in any way they
would like, can use the remaining pins.
In this case Honda chose to use two of
them as a SCS.
To short the SCS you need to jump pins
4 and 9 as shown in Image 3-3. That
will be the 4th pin from the top left corner when looking at the mating face of
the DLC and the wide part of the connector is at the top and the 1st pin on the
bottom left corner when looking at the
mating face of the DLC and the wide
part of the connector is at the top. You can always check the wire colors on the
backside of the DLC; jump the brown and black wires.
Image 3-4 Jumping SCS
The 1998 Honda Accord service manual
actually lists a special SCS jumper for
this application; however, it was never
produced. Honda recommends shorting
the SCS connector with the Honda
OEM scan tool. Manually shorting this
connector works fine!
Now is where it gets interesting! You
can indeed jump the SCS with the OEM
scan tool. You navigate to the proper
place in the scan tool menu and jump
the SCS by picking “Jump SCS”. The
only problem is when you leave this
area to do anything else with the scan
tool; you loose the SCS jumpered
condition. As the Honda OEM scan tool
is programmed at present, you cannot
jumper the SCS and use the tool for any
other useful purpose at the same time.
 All Rights Reserved 2000 Sure Seal Products Inc
This manual printed 4/9/00 from the file pgmfiobd_002.