Download Service manual - SPIDER
Transcript
RANSOMES SPIDER SERVICE MANUAL ± 5 mm 1 2 2 Fig. 94 Fig. 95 2.20 Adjusting the lifting rods - CAUTION! The locknuts have left and right threads! Right Left Fig. 96 2.21 Changing the servomotor controller Disassembly: - Disconnect the battery - Disconnect the input cables - Remove the servomotor lever and the servomotor Assembly: - Assemble the servomotor - Check and if necessary adjust the length of the rod (Fig. 99) - Fit the rod to the pump lever pin and the pin of the servomotor lever - Set the shaft of the servomotor and the shaft of the hydraulic pump to the zero (centre) position - Fit the lever on the servomotor shaft and tighten the locknut - Connect the wires of the servomotor regulator and the input controlling cables of the servomotor - Connect the battery - Turn on the main switch. CAUTION! After turning on the machine main switch, the lever must stop in the central position. If the lever does not stop in the central position but instead goes as far over GB-29