Download Service manual - SPIDER

Transcript
RANSOMES SPIDER
SERVICE MANUAL
± 5 mm
1
2
2
Fig. 94
Fig. 95
2.20 Adjusting the lifting rods
-
CAUTION! The locknuts have left and right threads!
Right
Left
Fig. 96
2.21 Changing the servomotor controller
Disassembly:
- Disconnect the battery
- Disconnect the input cables
- Remove the servomotor lever and the servomotor
Assembly:
- Assemble the servomotor
- Check and if necessary adjust the length of the rod (Fig. 99)
- Fit the rod to the pump lever pin and the pin of the servomotor lever
- Set the shaft of the servomotor and the shaft of the hydraulic pump to the zero (centre) position
- Fit the lever on the servomotor shaft and tighten the locknut
- Connect the wires of the servomotor regulator and the input controlling cables of the servomotor
- Connect the battery
- Turn on the main switch. CAUTION! After turning on the machine main switch, the lever must stop
in the central position. If the lever does not stop in the central position but instead goes as far over
GB-29