Download ATCA-7367 Installation and Use - Artesyn Embedded Technologies

About this Manual
About this Manual
Summary of Changes
Part Number
Publication Date
Description
6806800K72N
September 2015
Updated ATCA-7367 IPMC information in Table 9-9 on
page 199.
Updated the sections Standard Compliances on page
37, Installation on page 26, and Installation on page 30.
6806800K72M
June 2014
Re-branded to Artesyn.
6806800K72L
February 2014
Updated Table "Sensor Data Records" on page 199 and
Table "Face Plate LEDs" on page 67.
Updated Table "Get Handle Switch Command
Description" on page 177 and Table "Set Handle Switch
Command Description" on page 178.
Added a new section IPMI Boot Parameter on page 85,
updated the sections Advanced Menu on page 92, IPMI
Menu on page 103, updated the System Boot Options
Parameter #100 - Supported Parameters on page 156.
Added a new section Event Logs Menu under BIOS Setup
Utility section.
6806800K72K
September 2012
Updated Table 4-22
and Chapter 7, Using Standard IPMI Commands, on page
140.
6806800K72J
April 2012
Updated Table "Switch SW3 Settings" on page 49.
6806800K72H
March 2012
Added a Note in Standard Compliances on page 37.
Added Notice in Installation on page 26 and Installation
on page 30.
Updated EMC on page 25 and EMV on page 30.
22
6806800K72G
November 2011
Updated Introduction on page 77 and BIOS Setup Utility
on page 89.
6806800K72F
September 2011
Updated Table "Sensor Data Records" on page 199.
ATCA-7367 Installation and Use (6806800K72N)