Download GeoRef User's Guide

Transcript
21
Data Quality
Flin Flon (Manitoba/Saskatchewan)
Hawkesbury (Quebec/Ontario)
Lloydminster (Saskatchewan/Alberta)
Ottawa - Hull (Quebec/Ontario)
The UA data is shown correctly in GeoRef. For example, if a list of the UAs in Manitoba is selected, only the
Manitoba portion of the population of Flin Flon will be shown on that list. (If the selection of UAs for a province is
done by code then both the province code and the secondary province code should be considered.)
The GeoRef hierarchy shows CMAs/CAs as parts of provinces. There were five exceptions for the 1996 Census
where CMA/CAs cross provincial boundaries. These are:
Campbellton (New Brunswick/Quebec)
Pembroke (Quebec/Ontario)
Hawkesbury (Quebec/Ontario)
Lloydminster (Saskatchewan/Alberta)
Ottawa - Hull (Quebec/Ontario)
The CMA/CA data are shown correctly in GeoRef. For example, if a list of the CMA/CAs in New Brunswick is
selected, only the New Brunswick portion of the population of Campbellton will be shown on that list. (If the selection
of CMA/CAs for a province is done by code then both the province code and the secondary province code should be
considered.)
GeoRef shows the CSD parts of designated places (DPLs) and this is consistent with the hierarchy shown in Chart
Search.
4.4.5. Consistency with other Products
GeoRef refers to the census subdivision parts of designated places as ‘Designated Places’. This is inconsistent with
other products such as the Digital Boundary Files and the Digital Cartographic Files. In these products, whole
designated places are referred to as ‘Designated Places’.
The population and dwelling counts in GeoRef are consistent with those shown in the publication ‘A National
Overview’ (Catalogue No. 93-357-XPB). The ‘1991 Census Population by 1996 Boundaries’ in GeoRef is called
‘1991 Population’ in the publication.
4.5.
Completeness
Completeness expresses the degree to which the geographic entities (features) are captured according to the data
capture specifications. It also contains information about selection criteria, definitions used and other relevant
mapping rules.
Appendix B indicates the number of geographic units by province and territory. These numbers were checked on the
GeoRef files. GeoRef contains the correct number of geographic areas.
The completeness of the specific data in GeoRef is provided below.
Statistics Canada – Cat. No. 92F0085XCB
GeoRef