Download GeoRef User's Guide
Transcript
21 Data Quality Flin Flon (Manitoba/Saskatchewan) Hawkesbury (Quebec/Ontario) Lloydminster (Saskatchewan/Alberta) Ottawa - Hull (Quebec/Ontario) The UA data is shown correctly in GeoRef. For example, if a list of the UAs in Manitoba is selected, only the Manitoba portion of the population of Flin Flon will be shown on that list. (If the selection of UAs for a province is done by code then both the province code and the secondary province code should be considered.) The GeoRef hierarchy shows CMAs/CAs as parts of provinces. There were five exceptions for the 1996 Census where CMA/CAs cross provincial boundaries. These are: Campbellton (New Brunswick/Quebec) Pembroke (Quebec/Ontario) Hawkesbury (Quebec/Ontario) Lloydminster (Saskatchewan/Alberta) Ottawa - Hull (Quebec/Ontario) The CMA/CA data are shown correctly in GeoRef. For example, if a list of the CMA/CAs in New Brunswick is selected, only the New Brunswick portion of the population of Campbellton will be shown on that list. (If the selection of CMA/CAs for a province is done by code then both the province code and the secondary province code should be considered.) GeoRef shows the CSD parts of designated places (DPLs) and this is consistent with the hierarchy shown in Chart Search. 4.4.5. Consistency with other Products GeoRef refers to the census subdivision parts of designated places as ‘Designated Places’. This is inconsistent with other products such as the Digital Boundary Files and the Digital Cartographic Files. In these products, whole designated places are referred to as ‘Designated Places’. The population and dwelling counts in GeoRef are consistent with those shown in the publication ‘A National Overview’ (Catalogue No. 93-357-XPB). The ‘1991 Census Population by 1996 Boundaries’ in GeoRef is called ‘1991 Population’ in the publication. 4.5. Completeness Completeness expresses the degree to which the geographic entities (features) are captured according to the data capture specifications. It also contains information about selection criteria, definitions used and other relevant mapping rules. Appendix B indicates the number of geographic units by province and territory. These numbers were checked on the GeoRef files. GeoRef contains the correct number of geographic areas. The completeness of the specific data in GeoRef is provided below. Statistics Canada – Cat. No. 92F0085XCB GeoRef