Download User Guide

Ring Decay
NOTE: If decay runs through a section, B.Ht will enter by default. Top height
and bottom height are entered by default, except for the segments
where decay starts and stops.
Inner Breadth
(InBrd)
10. S/M - Single or mixed decay <Enter>.
Inner Width
(InWth)
11. %- If there is mixed decay, then indicate the % of one decay in the cross
sectional area. If there is no mixed decay press <Enter> to accept the
100% default and move to the next field.
Outer Breadth
(OutBrd)
NOTE: For single decay, accept the 100% default. Mixed decays MUST have
the decay measures duplicated for each decay in the mix.
NOTE: If one of the decays in a mix terminates while the other decay(s)
continue, continue the mix until the other decay(s) terminate and enter
a mix % of 1% for the terminated decay.
12. Ent - Describe the entrance of decay. Press <F2> and make a selection
from the pick list <Enter>
13. Comp - Compound decay description code. Press <F2> and make a
selection from the pick list <Enter>. This field will populate all of
the decay descriptor fields.
38 • Using the Handheld
08/08/2003
User Guide Volume and Decay Data Collection and Edit System