Download Installation manual
Transcript
be assured Figure 1-45 External sensors are connected to the Sensor Pod via a plug-in connector at the top-rear. Insert wires and rotate connector screws clockwise to tighten wire lugs [1] Figure 1-46 Pinouts for Sensor Pod external sensor connections [1] 26 September 2008 NV-72-0036-01-INST Env Std Revision 1 Page 43 of 55 Copyright © EnviroPoint Systems Pty Ltd 2009. Commercial in Confidence. All rights reserved. Copying of this document, use and communication of its contents is not permitted without written permission. Further distribution only as approved by EnviroPoint Systems Pty Ltd