Download Installation manual

Transcript
be assured
Figure 1-45 External sensors are connected to the Sensor Pod via a plug-in connector at the top-rear. Insert wires
and rotate connector screws clockwise to tighten wire lugs [1]
Figure 1-46 Pinouts for Sensor Pod external sensor connections [1]
26 September 2008
NV-72-0036-01-INST Env Std Revision 1
Page 43 of 55
Copyright © EnviroPoint Systems Pty Ltd 2009. Commercial in Confidence. All rights reserved. Copying of this document, use and communication of its contents is
not permitted without written permission. Further distribution only as approved by EnviroPoint Systems Pty Ltd