Download Installation manual

be assured
1.4.6.9
Pod (Node) Configuration
Figure 1-30 Node Application Page
Node application pages allow you to configure individual system nodes.
Point Name
Displays the name of the node as it appears to the system.
Change name to
Select a name which describes the node, if required.
Unit serial number
Already entered.
Location
Physical location of the node (sensor pod placement).
Change unit
Used when swapping pods at the node.
Unit Type
The type of pod as defined by Accsense, Inc.
Description
A description associated with the node.
Point Active
Node status (active or not).
Point verified
Click this box to verify the point when saving. Non-verified points
appear grayed out on the screen and no data will be saved. A
verified system can contain non-verified points.
Point alarm timeout
Set time in minutes between last data received from this node
and an alarm.
26 September 2008
NV-72-0036-01-INST Env Std Revision 1
Page 30 of 55
Copyright © EnviroPoint Systems Pty Ltd 2009. Commercial in Confidence. All rights reserved. Copying of this document, use and communication of its contents is
not permitted without written permission. Further distribution only as approved by EnviroPoint Systems Pty Ltd