Download MobIP Webinterface User's Manual

TOPEX MobiLink IP
User`s Manual
For Ethernet network connection:
Use standard UTP network cable (CUT 5) fitted with RJ45 connectors at both ends. The
cable can be either straight-through or crossover, since the MobiLinkIP is auto-crossover. One
short length of RJ-45 cable is supplied with the TOPEX MobiLinkIP interface.
Use either a 10Base-T or a 100Base-T connection.
Figure 5: Connecting the LAN cable (UTP- CAT5)
The network cable is to be inserted with one end into the RJ-45 socket of the MobiLinkIP
device labelled ETH. The opposite end of the UTP cable can be inserted directly into a PC or in
switches or hubs. The STATUS indicator LED of the MobiLink case will light up showing physical
connection and will blink to indicate data traffic on the respective Ethernet interface.
Power supply:
To power the MobiLinkIP unit, insert the jack of the power supply adapter into the supply
connector. Do not yet plug the adapter into the 230VA.C. mains outlet on the wall. The special
adapter from Topex, which is part of the MobiLinkIP package, supplies the voltage required to
power the equipment. It is an external power supply adapter.
Note: The adapter is the disconnection device (there is no POWER switch), so the 230 VAC
socket-outlet shall be installed near the equipment and shall be easily accessible.
TOPEX S.A.
+4 021.408.39.00
http://www.topex.ro
Page 18 of 88