Download MobIP Webinterface User's Manual

Transcript
TOPEX MobiLink IP
User`s Manual
6.6.1
PBX > Status
Displays the current state of the ports of the embedded “phone exchange” as well as the
states of the calls:
There are two sections, PBX Ports and respectively Calls.
In the stand-by state shown above, both ports are “free” and no info about calls is
displayed, since there are currently no conversations going through the MobiLinkIP.
PBX ports
Shows the state of the two mobile (GSM) interfaces of
the equipment, from the point of view of the call control
application. They may be FREE (available), BLOCK (blocked for
calls) or BUSY (in a call).
Note: The display “BLOCK” means that NOW the
respective Mobile interface is not available, but it may have
several different reasons:
The module was disabled from the
Web interface, it does not have a good
SIM, or simply the device has been
rebooted and the respective module is in
the initialization or searching phase, and
after a delay it may become again
available, such as shown below!
TOPEX S.A.
+4 021.408.39.00
http://www.topex.ro
Page 54 of 88