Download MobIP Webinterface User's Manual

TOPEX MobiLink IP
User`s Manual
5.7
POWER UP
Switch the MobiLinkIP on - the indicator LEDs will light up.
Remember that the adapter is the disconnection device (there is no POWER switch on
MobiLink IP), so the 230 VAC socket-outlet must be installed near the equipment and must be
easily accessible.
5.8
STATUS INDICATORS
MobiLink IP has three optical indicators (bicolour LEDs - red and green or red and yellow)
that shows the status of the device, respectively of the Ethernet interface and that of the two
mobile modules.
The indicators may light up continuously in red,
orange or green color, or flash to show status and data
traffic.
The three LEDs are located on the upper right
corner of the MobiLinkIP case, above the two slots for SIM
cards.
They are labelled respectively STATUS, MOBILE1 1
and MOBILE 2.
Figure 8: LEDs location
Significance of LED indicators:
STATUS: Shows the state of the equipment. Indicates the proper power supply and the
state of the Ethernet interface of MobiLinkIP.
Off = device not powered (no supply voltage), On, Red color = no ETH network is
connected, On, Orange color = ETH port connected to the local network, but no traffic, Orange
blinking = ETH port connected and data traffic present.
MOBILE 1: Shows the state of the first mobile module.
Off = not installed (the respective module is disabled from software), blinking red = not
registered or SIM not present, lights up green = mobile module1 free (available), lights up red =
mobile module1 busy (in a call).
MOBILE 2: Shows the state of the second mobile module, same significance as first
mobile.
Off = not installed (the module 2 is disabled from software), blinking red = not registered
or SIM not present, lights up green = mobile module2 free (available), lights up red = mobile
module 2 busy (in a call).
TOPEX S.A.
+4 021.408.39.00
http://www.topex.ro
Page 24 of 88