Download User Manual - Australian Thermal Imaging

User Manual
Button A:
y
When there is no menu displayed in live thermal image, press it to select the
temperature setup menu at the right side of the image.
Button C:
y
Press it to cancel a dialog box or menu and return to the live thermal image
Button S:
y
Functions are the same as button S on the camera:
y
Press it to freeze a live thermal image and press it again to save it into the built-in flash
memory or SD memory card.
y
Press it to toggle between spots and areas while doing spot and area analysis on live or
frozen or saved thermal images
y
Press it to switch between horizontal and vertical coordinate systems when doing line
analysis on live or frozen or saved thermal images
y
Press its to switch between options or buttons in menus or dialog boxes
Button Auto Mode:
y
When there is no menu displayed in live thermal image, press it to switch between three
modes Auto1, Auto2 and Manual, with the corresponding prompt “Auto1” or “Auto2” or
“Manual” shown in the status bar at the left bottom of the image.
Button Calibrate:
97